Vacuum the coils under or behind the fridge. Clogged coils can cause poor cooling. Check to make sure nothing is stuck in the condenser fan and that it spins freely (models with coils on the back won’t have a fan). To do this, unplug the fridge and pull it out.
Just so, Why is my fridge not getting cold but my freezer is?
When the fridge is not cold but the freezer is, the problem is probably tied to one of your refrigerator’s mechanisms not working as designed. … A small fan and motor are mounted near the evaporator, helping draw air over the coils and circulate it to the fridge and freezer.
How do I fix my refrigerator that is not cooling?
Similarly, What to do if refrigerator stops cooling?
Depending on the cause of your refrigerator not cooling, the following procedures might help.
- Make sure your fridge is getting power. …
- Take a look at your owner’s manual. …
- Check the refrigerator thermostat. …
- Test the seals on your fridge doors. …
- Determine whether the refrigerator is level. …
- Clean the condenser coils.
What is the first thing to check when a refrigerator stops working?
If Your Fridge Has Stopped and the Light is Off
As obvious as this sounds, often a fridge shuts down completely because it’s simply getting no power. The first thing to check is the breaker (in your home’s electrical service panel) of the circuit serving the fridge.
How do I run a diagnostic on my Whirlpool refrigerator?
To start with we need to start the refrigerator’s diagnostic mode. To do this open the refrigerator door and press one or both door switches, depending on your refrigerator type. Next press the refrigerator temperature (+) button three times in ten seconds and release the light switch or switches.
How long do I unplug my fridge to reset it?
Can you reset a refrigerator by unplugging it?
Unplug your refrigerator
Disconnect your fridge from its power source by removing the power cord from the wall outlet. You may hear some whooshing or knocking noises after you do so; that’s normal. Make sure your fridge stays unplugged for several minutes, otherwise the reset won’t work.
How do you unclog a refrigerator coil?
How to clean refrigerator coils: A step-by-step guide
- Step 1: Gently pull the refrigerator away from the wall. …
- Step 2: Unplug the refrigerator. …
- Step 3: Locate the coils. …
- Step 4: Start vacuuming. …
- Step 5: Use the paintbrush to remove any stubborn bits of dirt. …
- Step 6: Vacuum up all the dirt you knocked loose onto the floor.
Can Dirty coils affect cooling in a refrigerator?
When coils are dirty with dust or pet hair, the refrigeration process is hindered, which can prevent the appliance from cooling properly and efficiently. … Soon, food spoils, energy bills for running your fridge can rise up to 35%, and the appliance that should last for 12 to 14 years breaks down early.
What are the signs of a bad refrigerator compressor?
You’ll know that your compressor is bad when it starts making abnormal noises, the compressor overheats or not providing proper cooling, or when the fridge compressor clicks on and off too frequently.
Why would my refrigerator stop cooling and then start working again?
If the thermostat is adjusted incorrectly, the fridge will turn off and turn on again when the temperature increases. The compressors are responsible for providing power for the cooling process. In this case, it is suggested that you lower the thermostat setting to ensure the compressor keeps working properly.
How do you know if your refrigerator control board is bad?
Symptoms of a bad control board vary from cooling problems, erratic behavior, or the fridge not working at all. These control boards are in effect the same type of computer boards that are used in everyday computers and therefore susceptible to power outages, surges, spikes, and even to static electricity.
How do you reset a refrigerator?
Why would fridge suddenly stop working?
Typical causes are: 1) the door is left open frequently, 2) the condenser coils need cleaning, 3) the door doesn’t seal against the refrigerator box, 4) the cold control is set too cold, or 5) something is blocking the flow of cold air inside the fridge.
Will unplugging a refrigerator reset it?
Unplug your refrigerator
Disconnect your fridge from its power source by removing the power cord from the wall outlet. You may hear some whooshing or knocking noises after you do so; that’s normal. Make sure your fridge stays unplugged for several minutes, otherwise the reset won’t work.
Can I unplug my fridge for 5 minutes?
NO Do Not do that. . . If it is unplugged for some reason, wait for about 5 minutes before plugging it back in. . . If you have moved it whilst unplugged, on to its side, then leave it standing unplugged for about an hour, 12 hours would be safer.
Should I unplug my refrigerator if it’s not cooling?
If the coils inside the fridge/freezer are frozen over, then the air can not circulate over the coils and the fridge/freezer will not cool. By unplugging the fridge for 24 hours, the ice melts.
How long should you unplug your refrigerator to reset it?
Unplug the appliance from the wall socket for 30-45 minutes, then plug it back in. This will reset the device and in some cases it may be enough to completely fix the problem. If a hard reset did not solve the problem, measure the fluid temperature.
Does a fridge have a reset button?
Most don’t automatically reset. If the appliance has a reset button, it should just need to be held in for 30 seconds to correct the fridge. Some refrigerators, including Maytag and Amana, need to have the lock button and the reset or auto buttons held at the same time to reset the fridge.
How do you clean the coils on a Whirlpool refrigerator?
What are the symptoms of a dirty condenser coil?
If a condenser coil is dirty or fouled, its ability to reject heat is severely affected.
…
The three causes for high discharge temperatures are:
- High condensing temp;
- Low evaporator temps; and.
- High compression ratios.
What happens if refrigerator coils are dirty?
When the coils are clogged with dirt and dust, they can’t efficiently release heat. The result is your compressor works harder and longer than it was designed to, using more energy and shortening the life of your fridge. Clean the coils with a coil cleaning brush and vacuum.
