If you are referring to the 110 VAC power cord there is no problem as to which cord you use. However, the cables that connect from the PSU to the motherboard, devices, graphics card, etc. are not inter-changeable from one brand to another.
Just so, Can I use any AC power cord?
As long as the voltage is the same on the adapter and on the device (also, I have 9V DC and 9V AC adapters, do not mix these up) and be sure the current required is less than the amount that the adapter can source otherwise you risk overloading the power supply.
Are all power supply cords the same? The device-side of all PC cables is standardized. ATX 24-pin, EPS12V, PCI-e to the GPU, SATA—the wiring is known, and it doesn’t change. What isn’t standardized, however, is the layout of the PSU-side modular cable headers. … Like ESD, just because you’ve gotten away with mixing cables doesn’t mean you always will.
Similarly, Are power cables the same?
The number on the power cable determines the maximum safe voltage for that power cable. Therefore, in the US, any cable rated to 120V or higher will work fine. Now, you do have to worry about the current printed on the cable.
Does power cord make a difference?
For example, an “audiophile” cable can make bass notes even better, typically “more powerful”. The high end might sound “sweeter” and “more extended”. Well, as you can see, at a typical 1W output which is not an unusual, normal playback level for home systems, there’s no difference between the two cables.
Can I use 4.5 V instead of 5v?
They’re very stable on the output voltage and can kick out an amp or so. It’ll work fine.
Are all 12v chargers the same?
– Yes, they are likely interchangeable even though voltage is not the same. This is because the voltage difference is within specs, and I am GUESSING you could go even higher or lower in voltage. Those are some very beefy supplies by the way!
Are power supply power cords interchangeable?
Fortunately, they’re all the same; if the power cable fits into the PSU then it’s the right one. Generally, there are 2 different types for computer PSUs: the C13/C14, and the C19/C20.
Are all power cords Copper?
Most power cords use stranded copper wire. Those with two-prong plugs are ungrounded power cords. They have two separate twisted wire strands with individual insulation. … Remember do this before the copper oxidize.
What is C13 power cord?
IEC C14 to C13 cords are the most popular type of power cord used to power equipment in a data center server rack. Sometimes referred to as Jumper Cords, C14 to C13 cords are used to connect server and network equipment power supplies to a PDU or power strip.
Can I use a 12V power supply on a 19v?
A 12V adapter is unlikely to damage the components, but it is possible depending on the design and that’s why I mentioned it. The likelihood is probably vey tiny though so you can probably ignore that bit.
Are expensive power cables worth it?
An expensive cable might sound worse on your system than cheap cable. Or it might sound better. The important thing to remember is that even if it does sound better, it’s such a minuscule improvement that pretty much anything else you can do will have a greater effect on the sound.
Do power cords affect sound?
“Generic power cords actually do cause audible problems and that’s why a thoroughly engineered cord can make great improvements in music reproduction. … Of course, the connections between strands are imperfect and often poor because the copper oxide on their surfaces is semi-conductive, so it also creates noise.
Does power supply affect sound?
It depends entirely on what the external Linear PSU is being used to power. Even the type of filter capacitors used in this area can still affect the resulting sound AFTER going through a voltage regulator.
Can I charge a 3.7 V battery with a 5V charger?
Lithium battery with protection circuit board can be charged with 5V voltage(4.8V to 5.2V can be used). For 3.7V lithium batteries, the charge cut-off voltage is 4.2V and the discharge cut-off voltage is 3.0V. … Charging with 5V voltage is easy to cause danger of overcharging.
Can I use 19V charger for 12V?
No, don’t use it! The PSU will supply 19V (“voltage source”) and will probably damage the load. There are PSUs that limit output current by dropping/regulating the output voltage (which then can be considered a “current source”), but as long as the required current isn’t constant that wouldn’t work either.
Can I charge a 4.2 V battery with a 5V charger?
Can I charge a 4.2 V battery with a 5 V wall charger? – Quora. Yes you can, but the concern is what happens when the voltage exceeds 4.2 volts. In the case of lread acid or NiMH types nothing except a slight outgassing or mild heating, in the case of a li ion ,it could result in a fire. .
Can an AC adapter be used as a charger?
Adapters can sometimes be used as a charger, but a charger will never give you the same energy output as an adapter will. When it comes to some electronic devices such as laptops, your charging cord and your adapter are pretty much the same thing. Adapters will provide electrical current to something such as a laptop.
Are USB charging cables different?
Types of USB cables
Generally, there are two types of cables; Charging cables: can only charge your smartphone and other devices but cannot transfer data. These are commonly called “Charge-only” cables. Data cables: does both; charges your devices and transfer data.
Can I use 9v adapter for 12V router?
You cannot use that adapter because it is outputting more voltage than the original (12v vs. 9v). This has a likely chance of burning out one or more of the components within the router. … The output voltages must be identical.
Are computer power supply cables universal?
There is no universal standard for modular PSU output cables.
What gauge is computer power supply wire?
Standard PC power cables use 18, 16, or 14-gauge wire.
